Sony KP- 57WV600 - Manual (Page 3)

2
Installing
❑
To prevent internal heat buildup, do not block the ventilation
openings.
❑
Do not install the projection TV in a hot or humid place, or in
a place subject to excessive dust or mechanical vibration.
❑
Avoid operating the projection TV at temperatures below 5°C
(41°F).
❑
If the projection TV is transported directly from a cold to a
warm location, or if the room temperature changes suddenly,
the picture may be blurred or show poor color due to
moisture condensation. In this case, please wait a few hours
to let the moisture evaporate before turning on the projection
TV.
❑
To obtain the best picture, do not expose the screen to direct
illumination or direct sunlight. It is recommended to use spot
lighting directed down from the ceiling or to cover the
windows that face the screen with opaque drapery. It is
desirable to install the projection TV in a room where the
floor and walls are not of a reflective material.
Trademark Information
TruSurround and the symbol are trademarks of SRS Labs,
Inc. TruSurround technology is incorporated under license from
SRS Labs, Inc.
BBE and BBE Symbol are trademarks of BBE Sound, Inc. and are
licensed by BBE Sound, Inc. under U.S. Patent No. 4,638,258 and
4,482,866.
Steady Sound, Digital Reality Creation, Caption Vision,
CineMotion, Memory Stick, and Twin View are registered
trademarks of Sony Corporation. ClearEdge VM, HD Detailer, and
Uniform Brightness Screen are trademarks of Sony Corporation.
Owner’s Record
The model and serial numbers are located at the rear of the
projection TV, below the Sony logo, on the sticker, and also on the
TV box (white label). Record these numbers in the spaces provided
below. Refer to them whenever you call upon your Sony dealer
regarding this product.
CAUTION
How to reduce the risk of “Image Retention” on your
Projection TV
Bright, stationary images such as TV station logos displayed
on your TV can cause permanent damage to your TV,
resulting in retention of the image in the picture. Please
take the following steps to reduce the risk of causing image
retention:
View a variety of program sources or programming
material.
Image retention can occur when bright stationary images
such as TV station logos are viewed. Changing the program
material viewed reduces the possibility that a single image
will become imprinted on the picture tubes in your TV.
When viewing programs with stationary images, adjust the
picture setting to reduce the “Picture” and “Brightness”
levels. Image retention is accelerated by higher
“Brightness” and higher “Picture” settings.
Please see page 72 for instructions on adjusting picture
settings.
This will help you reduce the risk of causing image
retention.
IMAGE RETENTION IS NOT COVERED BY YOUR WARRANTY
As an E NERGY S TAR Partner,
Sony has determined that this
product meets the E
NERGY S TAR
guidelines for energy efficiency.
®
®
E NERGY S TAR is a U.S. registered mark. ®
Model No.
Serial No.
DA4X.book Page 2 Tuesday, April 23, 2002 2:48 PM