Samsung DVD-R2000 - Manual (Page 38)

38
Changing Setup Menu
Setting Up the Audio Options
1 In stop mode, press the SET UP button on the remote.
- Setup menu will be displayed.
2 Use the UP/DOWN button to select Audio Options.
Press the ENTER button.
3 Use the UP/DOWN button to select the desired item.
Then, press the ENTER button.
1) Dolby Digital Output
- PCM : Converts to PCM(2CH)
48kHz/16Bit audio. Select PCM when using a stereo amplifier.
- Bitstream : Converts to Dolby
Digital Bitstream (5.1CH).
Select Bitstream when using a Dolby Digital amplifier.
2) DTS
- On : Outputs DTS Bitstream via digital output only. Select DTS when connected
to a DTS DECODER.
- Off : Does not output digital signal
3) Dynamic Compression
- On : To select dynamic compression.
- Off : To select the standard range.
4) 2X Scan Audio
- On : Turns 2X audio on.
- Off : Turns 2X audio off.
Though 2X SCAN AUDIO is ON in the Setup Menu, no sound will be heard on discs
which are recorded with LPCM, DTS or MPEG-2.
5) Audio Reception: Stereo or SAP
4
Use the UP/DOWN button to select the desired item.
Press the ENTER button.
5 To make the setup menu disappear, press the SETUP button
again or press the RETURN/INPUT button.
NOTE
• Certain audio features of this product are manufactured under a license from Desper Prod-
ucts, Inc. Spatializer ® and circle-in-square device are trademarks owned by Desper Prod-
ucts, Inc.
• Manufactured under license from Dolby Laboratories. “Dolby” and the double-D symbol are
trademarks of Dolby Laboratories. Confidential unpublished works. ©1992-1997 Dolby
Laboratories Inc. All rights reserved.
• “DTS” and “DTS Digital Out” are trademarks of Digital Theater Systems, Inc.