Symbol Technologies MC9000-G - Manual (Page 155)

Settings 3-61
Table 3-9. Imager Reader Parameters
Reader
Parameters
Imager Values Description
Reader Type Imager Imager type scan engine is used.
Aim Type Trigger, Timed hold, Timed
release Trigger mode: On/off controlled by the trigger.
Trigger hold mode: Trigger can be released but it remains active for
the specified period of time.
Timed release mode: Activation stops after a specified period of time,
even if the trigger is held.
Aim Duration 0-60,000 ms Sets the Aim Duration time duration (0-60,000 ms in increments of
100 ms).
Aim Mode Dot, Slab, Reticle, None Use only None (no aiming) or Reticle (reticle aiming).
Beam Timer 0-60,000 ms Sets the maximum amount of time that the laser remains on (0-60,000
ms in increments of 100 ms). A value of 0 sets the laser to stay on.
Pointer Timer 0-60,000 in increments of
100ms Pointer Timer is not supported.
Image Capture
Timeout 0-60,000 in increments of
100ms Image Capture Timeout is not supported.
Image Compress
Timeout 0-60,000 in increments of
100ms Image Compress Timeout is not supported.
Linear Sec All codes *2,
All Codes *3
Long*2, Short*3
Short, Redun
Short, Codabar
Sets the number of times a barcode is re-read to confirm an accurate
decode.
All codes *2 : Two times read redundancy for all bar codes.
All codes *3 : Three times read redundancy for all bar codes.
Long *2 Short *3: Two times read redundancy for long bar codes,
three times for short bar codes.
Short, Redun: Two times read redundancy based on redundancy flags
and code length.
Short, Codabar: Two times read redundancy if short bar code or
CODABAR).
Focus Mode Fixed, Auto, Smart Fixed mode is the only focus mode supported.
Focus Position Far, Near Specifies the Fixed setting, focus position for Far is 9 inches and focus
position for Near is 5 inches.