Sharp CD2200M - Manual (Page 14)

EN-13
* Suppose you want to set Program Lock ON.
x 2
Procedure
3 2
STOP
CLEAR
CUSTOM
HELP
1 Press the CUSTOM HELP pad
twice within 2 seconds.
2 Enter 3, 2 for Program Lock
ON.
3 Press the START pad to
save the setting. START
4 Press the STOP/CLEAR pad
to exit from the Custom Help
Function.
NOTE : If you select Program Lock OFF, the LOCK
indicator in the display will disappear when you press
the START pad.
Operation when Program Lock ON is set
KEY
Operation
Custom Help Title
When Program
Lock ON is set
1
Selecting Memory
Input Method no operation
2
Selecting Auto Start
Operation no operation
3
Program Lock
Setting operation
4
Audible Signal
Sound Volume
Setting no operation
5
Cooking Completion
Signal Setting no operation
6 Memory Check operation
7
Counter Check/Clear check : operation
clear :
no operation
8
Air Intake Filter
Counter check, clear :
operation
set : no operation
9
Selecting Operation
in case of Magnetron
Failure no operation
x2/x3
Multiplication
Factors for Double/
Triple Quantity check : operation
set : no operation
EXPRESS
DEFROST Express Defrost
Setting check : operation
set : no operation
4. Audible Signal Sound Volume Setting
The volume of the audible signal can be adjusted to
High, Medium, or Mute.
CH41 : High = Factory Setting
CH42 : Medium
CH43 : Mute
To set cooking completion signal volume
Press the CUSTOM HELP pad twice within 2 seconds then
enter the numbers
4, 1 for High
4, 2 for Medium
4, 3 for Mute
Press the START pad to save setting and the STOP/CLEAR
pad to exit from the Custom Help Function.
NOTE : Even when errors occur, your oven will not beep
in mute setting.
5. Cooking Completion Signal Setting
There is a choice of 4 different signals on your oven.
CH51 : 1 long beep = Factory setting
CH52 : Repeating long beeps
CH53 : 4 short beeps
CH54 : Repeating short beeps
To set the signal type
Press the CUSTOM HELP pad twice within 2 seconds then
enter the numbers
5, 1 for 1 long beep
5, 2 for repeating long beeps
5, 3 for 4 short beeps
5, 4 for repeating short beeps
Press the START pad to save settings and the STOP/
CLEAR pad to exit from the Custom Help Function.
6. Memory Check
Use this setting to check the programming for a certain
memory.
* Suppose you want to know the information
programmed into memory 1, programmed
for 4 minutes at 60% for the 1st stage and
2 minutes at 30% at the 2nd stage programmed Dual
Digit Input.
Procedure Display
1 Press the CUSTOM HELP pad
twice within 2 seconds and
enter 6.
CUSTOM
HELP x 2
6
CHECK NO.