Sharp TCADH2564RCZZ User Manual

Xe-a506 quick start guide, Connecting the barcode scanner, Preparing the cash register

Advertising
background image

XE-A506 Quick Start Guide

The following describes how to get the cash register ready for operation. Follow these steps before using the cash register for the first time.
Place the cash register on a stable, flat surface not subject to direct sunlight.

English

1

Connecting the Barcode Scanner

A barcode scanner is provided with the cash register. To use
the scanner, connect the scanner before turning on the register.

1.

Open the Scanner port cover at the right side of the register.

2.

Insert the connector of the
barcode scanner into the
Scanner port, and tighten both
screws on the connector.

CAUTION:

• Always unplug the power cord of the cash register

when you connect or disconnect the barcode scanner.

• Never connect devices other than the barcode scanner

before changing the interface setting. Otherwise
malfunction of the cash register will occur.

3

Preparing the Cash Register

1.

Push the printer cover forward and
detach it.

2.

Remove the white retainer at the
position shown right.

NOTE: Please keep this retainer for future

use when transferring the cash
register.

3.

Move the print head release lever
upwards as illustrated right.

2

Initializing the Cash Register

To ensure the cash register operates properly, please use the following procedure:

1.

Make sure the power cord plug is not inserted into the AC outlet.

2.

Insert the manager (MA) key into the mode switch and turn it to the PGM position.

3.

While holding down both the

}

key and the

l

key, insert the plug into the AC outlet. The buzzer will

sound three times and “***MRS.***” will be displayed.

4.

The cash register has now been initialized.
The register display will show “0.00” with “PGM”.

CAUTION:

To charge the rechargeable batteries, keep the power on for one or two days. Leave the register with the mode
switch in a position other than “OFF”.

NOTE: If you press a key by mistake, an error message may be displayed. Press the

l

key to clear message after installing paper rolls.

4

Installing the Paper Rolls

1.

Cut off approximately one revolution
of each paper roll. Make sure the
paper end is cut as illustrated right.

For receipt paper installation

2.

Set a paper roll in the paper cradle
of the receipt side (upper side) as
illustrated right.

3.

Insert the end of the paper into the
paper chute until it is caught by the
printer auto-feed and comes out
the top of the printer. If the printer
does not catch the paper, feed the
paper while pressing

}

.

4.

Cut off the excess paper with the paper cutter.

For journal paper installation

5.

Set a paper roll in the paper cradle of the journal side as
illustrated in step 2.

6.

Insert the end of the paper into the paper chute until it is
caught by the printer auto-feed and comes out the top of
the printer. If the printer does not catch the paper, feed
the paper while pressing

}

as illustrated in step 3.

7.

Insert the end of the paper into the
slit in the take-up spool and fold
the paper to front side, then wind
the paper two or three turns
around the spool shaft. (Press

}

to feed more paper if required.)

8.

Set the spool on the bearing, and
press the

}

key to take up

excess slack in the paper.

9.

Replace the printer cover.

REG

OPX/Z

MGR

PGM

X1/Z1

X2/Z2

OFF

VOID

MA

Retainer

Print head
release lever

Slit

Correct

Incorrect

To the printer

Incorrect

To the printer

Correct

Advertising