Siemens SIPASS STANDALONE ACS3110 - Manual (Page 11)

Change Program Master
9 Change Program Master
This procedure replaces the old Program Master by a new one. The old Program
Master is thereby voided from the SiPass standalone memory and the new badge
is declared as Program Master instead. This is helpful if e.g. an other Program
Master than the normal one was added to the memory during wake-up.
Present the new Program Master a further 5 times to step through the remaining
steps, back to Normal mode.
Normal
mode
Read
Open
Closed
Night lock
Add
Void
Program
Read
Open
Closed
Night lock
Add
Void
Program
Read
Open
Closed
Night lock
Add
Void
Program
Old Prog. Master
Read
Open
Closed
Night lock
Add
Void
Program
New Prog. Master Old Prog. Master
Enter
Program Mode Declare new
Program Master,
enter Void Mode Void old
Program Master,
enter Add Mode
Fig. 4 Change Program Master
Any new / unknown badge can be declared as new Program Master.
If change Program Master function is not desired, just present the old Program
Master again the necessary number of times to get to the desired programming
step.
11
Siemens Building Technologies
Fire Safety & Security Products 02.2005