System requirements – Samsung SW-232 User Manual
Page 3
ENGLISH
5
Upgrading the Firmware Flash Memory
Your CD-R/RW Drive
4
1. Connector for stereo headphones with a 3.6 mm stereo mini-jack.
2. Headphone volume control.
3. Emergency eject hole. (if the compartment does not open when you
press the Eject button, power off the computer, insert a pin or unfolded
paper clip in the hole and push firmly)
4. Indicator Light. (GREEN: Read RED: Record)
5. Disc compartment. (the compartment opens and closes automatically
when you press the Eject button)
6. Eject button.
The product firmware can be upgraded by downloading the updated file from the
following Web site:
http:// www.samsungodd.com
www.samsungelectronics.com
System Requirements
Before you install the CD-R/RW drive, we strongly recommend that you check that
your setup meets the system requirements listed below.
Item
Description
Computer
Intel Pentium II (or higher), 64 MB of RAM (or higher)
with an E-IDE interface
Disk space
700 MB minimum
Windows version
Windows 95 / 98 OSR2 / 2000 / ME or XP /
Windows NT 4.0 (or higher)
1. Two-pin digital audio output terminal for use with a sound or MPEG card
supporting digital audio features.
2. Four-pin sound output terminal for use with a sound card.
(refer to the sound card documentation for further details)
3. Master/slave select terminal.
4. 40pin host E-IDE interface connector.
5. 4pin power terminal.
1
2
3 4
5
6
1
2
3
4
5
General DMA Installation Guide
Windows 95/98/Me
Important!
Please read the entire DMA installation guide before installing your CD-R/RW drive.
About DMA Installation
For stable writing performance at high speeds, Installation of DMA transfer mode forE-IDE/ATAPI
interface is strongly recommended. We recommend DMA mode for fast writing.
DMA Setting
Before you install your CD-R/RW drive, we recommend to set DMA to enabled on your
PC system. See the following procedure to set DMA transfer mode in windows
oprerating system. (Windows 95 OSR2/98/ME)
●
Click on START
●
Click on Settings
●
Select Control Panel
●
Select the System Icon
●
Select the Device Manager panel
in System Properties
●
Expand the CD-ROM icon
●
Select your CD-R/RW drive
●
Click on the Properties button
●
Click on the Settings tab
●
Check the DMA checkbox to enables DMA.
●
Click OK
●
Restart your PC
Windows 2000/XP
Select the DMA mode by selecting [Start > Setting > Control Panel > System >
Device Manager > IDEATA/ATAPI Controller > Default/Assistant IDE Channel
Advanced Information]