Sony HT-SL7A - Manual (Page 16)

16
Multi channel surround setup
(continued)
Only when you use the speaker system
other than the supplied one, be sure to
set the following parameters.
The speaker size and sub woofer selection has been
preset to MICRO SP. (Micro Satellite Speaker)
according to the supplied speaker system. If you
change the speaker system, choose NORM. SP.
(Normal Speaker) to adjust the speaker size and sub
woofer selection. To select NORM. SP., turn off the
power, then turn on again while pressing the cursor
button U. (To reset to MICRO SP., do the same
procedure.)
Parameter Initial setting
L R (FRONT) LARGE
C (CENTER) LARGE
SL SR (SURR) LARGE
SW
(SUB WOOFER) S.W. YES
You cannot change the configuration if you choose
MICRO SP.
x Front speaker size (
L R
)
• If you connect large speakers that will
effectively reproduce bass frequencies, select
“LARGE”.
• If the sound is distorted, or you feel a lack of
surround effects when using multi channel
surround sound, select “SMALL” to activate
the bass redirection circuitry and output the
front channel bass frequencies from the sub
woofer.
• When the front speakers are set to “SMALL”,
the center and surround speakers are also
automatically set to “SMALL” (unless
previously set to “NO”).
x Center speaker size (
C
)
• If you connect a large speaker that will
effectively reproduce bass frequencies, select
“LARGE”. However, if the front speakers are
set to “SMALL”, you cannot set the center
speaker to “LARGE”.
• If the sound is distorted, or you feel a lack of
surround effects when using multi channel
surround sound, select “SMALL” to activate
the bass redirection circuitry and output the
center channel bass frequencies from the front
speakers (if set to “LARGE”) or sub woofer.*
1
• If you do not connect a center speaker, select
“NO”. The sound of the center channel will be
output from the front speakers.*
2
x Surround speaker size (
SL SR
)
• If you connect large speakers that will
effectively reproduce bass frequencies, select
“LARGE”. However, if the front speakers are
set to “SMALL”, you cannot set the surround
speakers to “LARGE”.
• If the sound is distorted, or you feel a lack of
surround effects when using multi channel
surround sound, select “SMALL” to activate
the bass redirection circuitry and output the
surround channel bass frequencies from the sub
woofer or other “LARGE” speakers.
• If you do not connect surround speakers, select
“NO”.* 3
Tip
*1–*3 correspond to the following Dolby Pro Logic
modes
*1 NORMAL
*2 PHANTOM
*3 3 STEREO