Sony TC-TX1 - Manual (Page 19)

GB
19
Chapter 6: Additional Features
Connecting an External
Aerial
To improve the FM reception
Connect an external aerial when the signal
reception is too weak with the supplied FM
lead aerial.
Connect an external FM aerial to the FM 75
Ω terminal, using a 75-ohm coaxial cable
and IEC standard socket connector.
To improve the AM reception
Connect an external aerial if the signal
reception is too weak after reorienting the
supplied AM loop aerial. Do not
disconnect the AM loop aerial.
Connect a 6- to 15-meter insulated wire (not
supplied) to the AM terminal and extend
the other end horizontally at a higher place.
Connect the y terminal to the earth.
Important
Earth the external aerial against lightning. To
avoid a gas explosion, do not connect the earth
wire to a gas pipe.
To check the timer settings
Press TIMER SELECT until “REC”
disappears and appears in the display
again.
The preset items appear sequentially.
To change timer settings
Repeat steps 1 to 10.
Connecting Optional
Equipment
Connecting an MD, DAT
deck, etc.
To make a digital recording with an
MD, DAT deck, etc.
Connect the DIGITAL (OPTICAL)
OUTPUT jack on the rear panel of the tuner
CD player to a recorder, deck, etc. that has
an optical connector.
To make an analog recording with an
MD, DAT, VCR deck, etc.
Connect the MD IN/OUT jacks (phono
jacks) on the rear panel of the stereo to an
MD, DAT, VCR deck, etc. with the Sony
RK-C315 connecting cord (not supplied).
To hear the VCR sound through the
connected speakers, connect the MD IN
jacks on the rear panel of the stereo to the
output jacks on the VCR. In this case,
connect the plugs to jacks of the same
colours.
For details, see the instruction manual for
each equipment.
To listen to the sound of the
connected equipment
Press FUNCTION repeatedly until “MD”
appears in the display.
Connecting cord RK-C315
(not supplied), etc.
MD/DAT/
VCR deck
to the output
jacks
Tuner CD
player
to the
input jacks
Digital cable POC-15A
(not supplied), etc.
MD/DAT
deck
CD OPTICAL
DIGITAL OUT
Tuner CD
player
to digital
input jack
IEC standard socket
connector (not supplied)
Earth wire
(not supplied)
Insulated wire
(not supplied)