Sanyo DS27820 User Manual
Page 8
8
8
➈
V-Guide Key (See pages 17 ~ 18.)
➉
Reset Key—Press this key twice to restore factory
settings. The TV will automatically start Channel
Search and clear all customized settings. These features
will automatically reset:
•
Picture/Sound Adjustments: Color, Tint, Contrast,
Brightness, Sharpness, Color Enhancer, Bass,
Treble, and Surround Sound
•
Channel Memory
•
Initial Channel to OFF
•
Audio to Stereo
•
Caption to OFF
•
V-Guide to OFF
•
PIP to OFF
•
Aspect Ratio to 4:3 (normal)
•
Menu Language to English
•
Clock and Sleep Timer (if previously set)
•
Video to TV (if previously set)
If desired, personal settings can be made again using
the menu options.
Power Key—Press to turn TV on or off.
Sleep Key—Press this key, then press the “0” key to
set the Sleep Timer. The desired time can be set from
30 minutes up to 3 hours in 30 minutes increments.
Sleep Timer will switch off the TV automatically.
Note: The Sleep Timer cancels when the TV is turned
off or if a power failure occurs.
Recall Key—Select a channel then select another
channel using the number keys. Press Recall to switch
between the channels.
Display Key—Press once to display the channel
number and time. Press twice to display the channel
number continuously. Press again to remove the
display.
PIP Keys—See pages 14 ~ 16.
8
8
➈
➉
12
13
14
11
➠
Point towards TV
11
12
13
14
PROGRAMMING THE REMOTE CONTROL
Find your VCR, DVD, and Cable Box, brand codes in
the charts on page 9.
❷
Press and hold the VCR or AUX (Auxiliary) mode
key while entering a three-digit code number. Then
release the mode key.
If the code was accepted, the mode key will flash 5 times
after it is released. If you entered an invalid code, the mode
key will not flash. Check the code number and repeat Step 2.
The VCR mode will accept only VCR code.
The AUX mode will accept code types for DVD Players,
Cable Boxes, or a second VCR, but only one code at a time.
Perform Steps 1 and 2 for each piece of equipment you
have. After entering each code number check the unit’s
operation by pressing the POWER and/or CHANNEL
keys. If these keys operate your equipment, you have
probably entered the correct code number for that device.
If not, follow Step 2 and enter another code, if available.
After you have programmed the remote control and
confirmed its operation, enter your codes in the spaces
provided below for easy reference.
VCR Code:
Cable Box Code:
DVD Player Code:
15
15
REMOTE CONTROL KEYS