Skil 3800-02 - Manual (Page 50)

50
Basic Saw Operations
Sliding Base/Fence Extension
Extend and use sliding base/fence when
making severe bevel, severe miter or
compound cuts to provide sufficient (minimum 6”) spacing
from hand to saw blade.
Sliding Base:
1. Loosen the thumbscrew 1 in sliding base channel
(Figure 23).
2. Slide sliding base/fence 2 to the desired position.
3. Tighten thumbscrew 2.
Sliding Fence:
1. Unlock the fence locking lever 3 (Figure 24).
2. Slide fence to proper position 4.
3. Relock fence in place.
4. Move the head assembly to check clearance with fence.
During transportation, sliding base and
fence should always be secured in the full
in position.
Stop Block:
Stop block can be used to make repetitive length cuts.
1. Attach stop block 5 to extension rail 6 (Figure 25).
2. Loosen thumbscrew 7 on backside of stop block 5.
3. Slide stop block to desired length of cut.
4. Tighten thumbscrew.
Note: Stop block can be stored by loosening knob and
flipping stop block.
FIG. 23
1
FIG. 24
3
4
WARNING !
CAUTION !
2
FIG. 25
5
7
6