Sierra Monitor Corporation HRG015-W - Manual (Page 38)

HRX-OM-J049-A
Chapter 3 Transport and Installation
3.2 Installation HRG010-W HRG015-W
1st edition : Aug. 2006
Rev. A: May. 2007
3-16
3.2.8 Reinstallation of unit
When the unit is transferred to and reinstalled in a different place after operation at
the original place (including trial run), perform transporting and installation of the
unit according to the procedures described below and in Chapter 3.
„ Disconnection of power supply cable
Be sure to cut off the power supply when disconnecting the power supply cable.
z Only qualified personnel are allowed to install wiring.
z Be sure to cut off the power supply for safety. Wiring with the unit
energized is strictly prohibitted.
If the unit is relocated, only personnel with knowledge of the unit and
associated equipment are allowed to perform unit reinstallation.
Precautions described below must always be followed.