Sharp R-1501 - Manual (Page 10)

10
This Microwave Oven/Hood is designed for adaptation to three types of hood ventilation systems. Select the type
required for your installation.
Recirculating — non-vented, ductless. Follow installation procedure (A). Recirculating requires the use of the
Charcoal Filter, which has already been installed in the oven.
Horizontal Exhaust — outside ventilation. Follow installation procedure (B).
Vertical Exhaust — outside ventilation. Follow installation procedure (C).
The unit is shipped assembled for recirculating.
NOTE: 1. The Exhaust Damper Assembly 9 is not required for recirculating operation.
2. The Charcoal Filter should be replaced every 6 to 12 months, depending on use.
3. The Charcoal Filter RK-240 is also sold as an accessory. See Page 14 for ordering information.
1. Remove 2 screws from back edge and 3 screws from the top center of Fan Cover Bracket. Save 2 screws to be
used later and discard remaining 3. Remove Fan Cover Bracket by sliding it in the opposite direction of the arrow
on the Fan Cover Bracket, as shown in Figure 7.
2. Lift Hood Fan Unit carefully and slip wires out of cavity. See Figure 8. CAUTION: Do not pull or stretch hood fan
wiring.
3. Rotate the Hood Fan Unit 180˚ so that the fan blade openings are facing the back of the oven. See Figure 9 (A).
Replace Hood Fan Unit into the oven. Be careful not to pinch the wire and the Hood Fan Unit. See Figure 9 (B).
4. Put the wire back into the cavity. See Figure 10.
U N P A C K I N G A N D I N S T A L L A T I O N I N S T R U C T I O N S
8 VENTILATION SYSTEM (PREPARING OVEN FOR
INSTALLATION)
(A) RECIRCULATING: NON-VENTED, DUCTLESS
OPERATION
Figure 7
Figure 9 Figure 10
Save fan cover bracket for
future instructions.
Figure 8
(B)
(A) Rotate 180˚
(B) HORIZONTAL EXHAUST: OUTSIDE VENTILATION