Sun Microsystems SERVER 1290 - Manual (Page 52)

40 Netra 1290 Server Installation Guide • May 2006
8. Booting the Solaris Operating System.
9. Installing the Lights Out Management packages from the Sun Microsystems
software download center.
Setting Up the Hardware
▼ To Install and Cable the Hardware
1. Connect a terminal to the system controller board serial port ( FIGURE 1-26 ).
2. Set up the terminal to use the same baud rate as the SC serial port.
The serial port settings of the System Controller board are:
■ 9600 baud
■ 8 data bits
■ No parity
■ 1 stop bit
On/Standby Switch
The On/Standby switch is a rocker switch with two positions, On and Standby.
FIGURE 2-1 illustrates the switch and its location.
FIGURE 2-1 Netra 1290 Server On/Standby Switch
On/Standby
switch