Samsung HT-DM150 - Manual (Page 39)

SETUP
38
To increase Effect level
Adjusting DSP Sound Parameters
You can fine-adjust DSP modes more minutely by changing
three parameters—room, liveness, and reverberation.
To increase Effect level
• The effect level can be set in steps from 1 to 4 EFFECT1
➔
EFFECT2
➔
EFFECT3
➔
OFF(DEFAULT).
Each time the button is pressed the selection moves to the next
effect.
• The higher the number, the stronger the DSP surround effect will be.
Effect
Press the DSP/DPL II Effect button.
What is a Effect?
This sets the strength of
the DSP mode.
• This function works only in the DSP Mode.
• This function works only in the DSP Mode.
2 3
Press the Sound Edit button.
• Each time you press the button, the
indication on the display changes as follows:
1
Press the DSP/DPL II Mode button.
Press the Left/Right ( / ) button to
adjust the DSP sound parameter.
▲
▲
ROOM : To adjust the resonance based on the room size.
The larger this value is, the more effective the
resonance is (from 04 to 16 by 2 steps).
LIVE (Liveness) : To adjust the liveness. The larger this
value is, the more liveness is obtained
(from 04 to 16 by 2 steps).
REVERB (Reverberation) : To adjust the reverberation time
of the sound (from 0.0 msec to
1.6 msec by 0.2 msec steps).
00 F 00 00 R 00 REAR SW
Normal
indication
(canceled)
REVERB LIVE ROOM