Ardo WDN 1495 LW - Manual (Page 9)

9
SM2716
CONTROL PANEL
GB
EASY LOGIC: The EASY LOGIC system automatically regulates the wash time and water and power
consumption according to the actual amount of washing placed in the drum. The ½ load function is
therefore redundant in that the EASY LOGIC system automatically sets the wash parameters.
DRY: When the dry option is selected, the washing will be dried by a current of hot
air at the end of the wash phase. The duration of the drying phase is selected by
repeatedly pressing button G. The time depends on the amount of washing loaded,
the type of fabric and the degree of dampness to retain.
When this option is enabled, the no-spin function is disabled. At the same time, the
detergent dispenser must not be placed in the drum as it could melt during the drying
phase and damage both the washing and the washing machine.
START: During the phase for selecting programs and washing options, the start LED
stays off. To confi rm the selections and start the wash cycle, press “Start” button H.
The LED will light up.
TECHNICAL CHARACTERISTICS
Width (cm)
Height (cm)
Depth (cm)
MODEL:
Dimensions
Max. spin speed (rpm)
Water pressure
Electrical connection see rating plate
W D N 1 4 9 5 LW / B / A
59.5
85.0
59.0
1400
9.0
kg. 5,0
kg. 3,5
140’ - 150’
90’ - 110’
160’ - 180’
120’ - 140’
Max. load
iron dry dry
iron dry dry
RECOMMENDED DRYING TIMES
Resistant fabrics
Delicate fabrics
Max. load (kg) 5,0
Max. load (kg) 3,5
The drying times indicated in the table are purely indicative and may vary substantially according to the
type of fabric, the spin speed and the amount of washing loaded.
AUTOCLEAN: Frequent washes at low temperatures can lead to the formation of mould and create
bad smells inside the washing machine. The AUTOCLEAN function thoroughly cleans the washing
machine by means of a special 90°C cycle.
AUTOCLEAN will automatically suggest starting the cleaning programme after a certain number of
washes, if no hot washes have been carried out during this time. This it does by means of a fl ashing
on the display.
Remove all the washing from the drum, place knob I in position Autoclean, and press Start button
H to start the cycle.
The AUTOCLEAN programme can be effected at any time or when circumstances require it. Remove
the washing in the drum and close the door. Place knob I in position Autoclean, keeping button
pressed until appears on the display. To start the AUTOCLEAN cycle, press the Start
button H