Sirius Satellite Radio SIR-ALP10T - Manual (Page 17)

17 SIR-ALP10T Operation and Installation Guide 17 SIR-ALP10T Installation Guide
The traffic information setup controls the
way the traffic and navigation information is
displayed. To review and/or change these
parameters:
1. Turn on the Alpine navigation system
and monitor/display.
2. The navigation system will display a
disclaimer notice. Select
I ACCEPT to
proceed.
3. When the map screen is displayed,
touch the
menu icon in the upper
right corner of the display screen.
4. When the Nav Menu screen is
displayed, touch the
Setup button, or
select it by tilting the joystick to highlight
it and press the
ENTER button.
5. When the Setup screen is displayed,
touch the
Traffic Information selection,
or select it by tilting the joystick to
highlight it and press the
ENTER
button.
Traffic Information Setup
6. The next Setup screen will display the
system status and the traffic setup
parameters.
The following sub-sections explain each of
the traffic information setup parameters.
System Status
System Status indicates the strength of the
SIRIUS data signal being received:
(No Signal)
(Weak Signal)
(Strong Signal)
(Very Strong Signal)
Traffic Icons
When the system receives traffic incident
information, you can choose whether to
display the traffic incident information as
icons on the map screen. Traffic incident
icons are displayed when the map scale is
set between 1/32 mile (50 m) and 5 miles
(10 km).