Sirius Satellite Radio SIR-ALP10T - Manual (Page 9)

9 SIR-ALP10T Operation and Installation Guide 9 SIR-ALP10T Installation Guide
DATA
Antenna (21’ cable)
Mount on Roof of Vehicle
Black (Pin 3) – Connect to Chassis
Ground (–)
2.5-meter Ai-NET Cable
(Connect to Alpine SAT Ready
Headunit or Signal Processor)
Yellow (Pin 2) – Connect to
Battery Positive (+)
Right-angle
SMB Connector
Note: It is important to follow the Input/Output configuration of the Ai-NET system. The
directionality is in reference to the Audio Path.
Gray Ai-NET connectors are Audio Input
Dark Blue Ai-NET Connectors are Audio Output. (Exception is the connector on an Alpine
Headunit – it can be either Input or Output depending on the position of the Ai-NET switch
on the bottom of the unit.
3.5-meter Data Cable
(Connect to Alpine NVE-N872A)
Ignition
Switch
Red (Pin 1) – ACC, Connect to
Ignition Switched Circuit
Note: Connect the RED (ACC/IGN) wire
ONLY when using the SIR-ALP10T
without an Alpine headunit.