2-3 dynamic motion control (dmc)playback, 2 playback, 2-3 dynamic motion control (dmc) playback – Sony MSW-M2000 User Manual

Page 54

Advertising
background image

Chapter 4

Recording and Playback

4-12

Chapter 4

Recording and Playback

4-2 Playback

Storing a varying playback speed in
memory

To store the playback speed for DMC playback, use
the following procedure.

Note

Make sure that the TSO PLAY of setup menu item 111
is set to DIS beforehand.

1

Press the DMC EDIT button, turning it on.

2

Either while playing back the recorded tape, or
during recording, press the ENTRY button and one
of the following buttons simultaneously, to set the
start and end points.
• On-air start point: AUDIO IN button
• Speed variation start point: IN button
• Speed variation end point: OUT button
• On-air end point: AUDIO OUT button

Each press turns the corresponding button on.

3

Press the search dial or the SHUTTLE button or
VAR button to enter shuttle/variable speed mode.

The SHUTTLE/VAR indicator lights.

Waiting for the on-air cue
before starting DMC
playback

On-air start point Preroll point

Speed variation start point

Speed variation end point

On-air end point

Stop

Press the REVIEW button.

Press the REVIEW button again
at the on-air cue.

Normal speed
playback

DMC playback

Normal speed playback

Stop

Starting DMC playback
immediately after preroll

Normal speed
playback

DMC playback

Normal speed playback

Press the PREVIEW button.

Z

2

5

1,4

7 3 3,4,6

4-2-3 Dynamic Motion Control (DMC) Playback

Overview

DMC playback allows you to vary the playback speed
for a certain section of a tape, in variable speed mode
(from –1 to +3 times normal speed for digital Betacam
playback, from –1 to +3 times normal speed for MPEG
IMX playback, from –1 to +2 times normal speed for
Betacam SX playback, or from –1 to +3 times normal
speed for analog Betacam playback), and store the
varying speed in memory for later playback at the
same varying speed.

For example, during a live broadcast of a sporting
event you can set the start and end points of highlights
while recording, and then provide immediate DMC
playback of those highlights.

During DMC playback the tape moves as shown in the
following figure.

(Continued)

Advertising
This manual is related to the following products: