Sun Microsystems X1150A - Manual (Page 42)

20 Sun GigaSwift Ethernet Adapter Installation and User’s Guide • February 2003
▼ To Set the GigaSwift Ethernet Device Primary Boot Device
Use this procedure only if you want the GigaSwift Ethernet device to be your
primary boot device.
1. List the network devices on your system.
2. Set the Sun GigaSwift Ethernet device to be your default boot device, type:
Note that the correct command has a space rather than = between boot-device
and /pci@1f,2000/pci@1/network@4 .
Rebooting the System
After verifying the adapter installation, use the boot -r command to perform a
reconfiguration boot on your system.
ok show-nets
a) /pci@1f,2000/pci@1/network@4
b) /pci@1f,4000/network@1,1
q) NO SELECTION
Enter Selection, q to quit: q
ok setenv boot-device /pci@1f,2000/pci@1/network@4
ok boot -r