Sharp EXTRON SYSTEM 68-409-01 - Manual (Page 4)

Extron • System 8/10 P
LUS
• User’s Manual • P/N 68-409-01 Rev. C
Sharp Installation Configuration and Connections
Page 4
Sharp XG-1000/E1100 Projector Configuration
Verify that the System 8/10 P LUS is already configured for the Sharp projector.
The general setup is explained on page 3-4 and the switch settings for the Sharp
projector are repeated below.
1. Use a small screwdriver to remove the access cover from the System 8/10 P LUS
front panel. See bottom of page 3-3. The label on the back of the access cover
also has the configuration information.
__________ Before changing anything, remove the AC power cord to the System 8/10 P
LUS
to verify that the main power is OFF; also turn the projector power OFF.
2. Set the switches as follows:
Config Model Rotary Switches Cable SW15 Settings Comm
as RS1 RS2 RS3 RS4 J2/J3 1 2 3 4 5 6 7 8 9 10 Adapter
4
Sharp XG 0 0 F 3 J2
↑ ↓ ↑ ↓ ↑ ↓ ↓ ↓
¯
↑ ↓
26-426-01
3. Use a grease pencil (or other rub-off marker) to mark the space on the label next
to “Sharp XG”.
4. Locate the switcher’s Address DIP switches on the rear panel, lower right.
Unless this is part of a master/slave system, set #3 and #5 to the up position and
the others down. See picture to the left.
Use the illustration on the next page to do the following steps.
5. Connect the Comm Adapter’s miniphone connector to the “Wired Remote” input
jack and the power plug to the Aux power port on the rear panel of the projector.
6. Connect the CC-50' (or CC-100') cable from the 9-pin male connector of the
Comm Adapter to the 15-pin HD “Projector Control” port located on the rear
panel of the System 8/10 P
LUS . (If you wish to make your own communications
cable, see page 3-2.)
______ Secure the screws on all D connectors.
7. Connect the BNC cables from the System 8/10 P LUS outputs to the Sharp
projector inputs according to the application requirements.
8. Apply Main Power to the System 8/10 P
LUS
by connecting the power cord. The
Main Power LED should light. Apply power to the projector.
9. Return System 8/10 P LUS and projector to normal operation.
_ RS5 is for
RGB switching
delay. See
page 3-4 for
more
information.
Configured For:
RS-232
3 4 5 6 7 8 9 10 1 2
SW15 DIP Switch
ON
RS5 RS2
RS2
RS1
RS3
RS4
RS1
RS3 RS4