Sharp EXTRON SYSTEM 68-409-01 - Manual (Page 7)

Extron • System 8/10 P
LUS
• User’s Manual • P/N 68-409-01 Rev. C
Sharp Installation Configuration and Connections
Page 7
System 8/10 Plus - Sharp XG-E1200U LCD Projector Cable Diagram
Use the illustration below as a guide when connecting the System 8/10 Plus to a
Sharp XG-E1200U projector. Refer to Sharp documentation to continue the
installation.
________ When the Wired Remote jack is installed, the projector’s IR Receivers are
disabled. This jack can be installed or removed at any time. Please perform the
basic projector setup before installing the Wired Remote jack.
________ If the installation includes looping (master/slave) switchers, see Chapter 5 of the
System 8/10 Plus User’s Manual.
________ If Video Loop Back is part of the installation, refer to pages 2-10 and 2-11.
Configuring the Projector
Please refer to your Sharp XG-E1200U Operations Manual to set up your
projector. Also, in order for the System 8/10 Plus to know whether the projector
is “ON” or “OFF”, the projector’s 5VDC output jack must be set to “LAMP”.
1. Select MENU.
2. Select SYSTEM SETUP.
3. Select DC 5V OUTPUT.
4. Using the buttons on the rear of the Sharp XG-E1200U, select
LAMP.
▲
▲
WIRED
REMOTE
COMPUTER
A U D I O I N
FOR PC98 MOUSE PC CONTROL
INPUT 1 OUTPUT COMPUTER RGB AUDIO OUTPUT
L R
R G B H V
INPUT 2 DC5V OUTPUT
-
MAX CURRENT 1A
+
VIDEO INPUT AUDIO INPUT
VIDEO OUTPUT
S-VIDEO VIDEO
L R
FILTER
ON
OFF
➶
See first
note below
➶
Power Plug
Adapter (26-446-01)
To Composite Video source (see last note on previous page)
➶
To S-Video source or
BNC-to-S-Video adapter
(26-353-01, male-to-male)
VIDEO INPUT
S-VIDEO VIDEO
SHARP COM
ADAPTER 26-426-01
➶