SUPER MICRO Computer 5015M-U - Manual (Page 43)

Chapter 5: Advanced Serverboard Setup
5-9
5-6 Adding PCI Cards
1. PCI Expansion Slots
Two riser cards are used to support add-on cards to the system. The SC815TQ-
R450U/SC815TQ-560U chassis can accommodate one standard size (full height
full length) and one low profi le PCI expansion card. When viewed from the chassis
front, the standard size card installs to the left and the low-profi le card installs to
the right side.
PCI cards are installed into riser cards that have been pre-installed to the system.
An additional two riser cards are included to support PCI-E add-on cards. See
confi guration list below.
2. PCI card installation
Before installing a PCI add-on card, make sure you install it into the correct riser
card. Begin by releasing the locking tab that corresponds to the slot you wish to
populate. Insert the expansion card into the correct riser card, pushing down with
your thumbs evenly on both sides of the card.
PCI Slot/Card Confi gurations
5015M-UR/5015M-NTR
Left Side Riser Card Expansion card supported
CSE-R1UU-UE8 (preinstalled) 1x UIO card and 1x PCI-E x8 card
Right Side Riser Card Expansion card supported
RSC-R1UU-E8R+ 1x PCI-Express x4 card
5015M-U/5015M-NT
Left Side Riser Card Expansion card supported
CSE-R1UU-2E8 (preinstalled) 2x PCI-E x8 cards
Right Side Riser Card Expansion card supported
RSC-R1UU-E8R+ 1x PCI-Express x4 card