Sony S-Frame 4-155-700-17 (1) - Manual (Page 69)

69 GB
Usi
n
g
wi
th
a
co
mp
u
te
r
Notes
• If a hub is used to connect this unit and your
computer, or if two or more USB devices,
including other printers, are connected to your
computer, a problem may occur. In such a case,
simplify the connections between your computer
and this unit.
• You cannot operate this unit from another USB
device being used simultaneously.
• Do not disconnect the USB cable from or connect
it to this unit during data communication or
printing.
• This unit does not support standby, sleep, and
hibernation modes and restarting from those
modes. Do not allow the computer connected to
this unit to switch to one of those modes during
printing. If you do so, printing may be failed.
• When printing is failed, remove a USB cable and
then connect it, or restart your computer. Then try
printing again.
• Operation with all computers that satisfy the
recommended system requirements is not
guaranteed.
• PMB supports DirectX technology and DirectX
installation may be required.
DirectX is available on the CD-ROM.
• If the PMB is installed on a computer on which the
Cyber-shot Viewer is already installed, the Cyber-
shot Viewer will be overwritten and replaced by
the PMB. The browsing folders once registered in
the Cyber-shot Viewer will be automatically
registered in the PMB.
Before connecting to a
computer
You need to prepare beforehand, depending on
how you connect this unit to the computer.
Using the internal memory of
this unit
You do not need to prepare before connecting.
Printing (for the first time)
The first time you connect this unit to a
computer to print, you must first install the
supplied printer driver.
For the printer driver installation method, see
page 73.
Printing (from the second time
onwards)
You do not need to prepare before connecting.
Connector: USB connector
Drive: CD-ROM drive (to be used for
software installation)