SIIG 133 - Manual (Page 5)

5
4. Remove the Driver diskette and restart Windows to complete
driver installation.
Verify Proper Installation for Windows 95B
1. Double click My Computer/Control Panel/System, then click
Device Manager .
2. Double click hdc; IDE dev, an entry, SIIG CN2487 UDMA133
IDE Controller , should be listed.
3. Highlight SIIG CN2487 UDMA133 IDE Controller and click
Properties . A message This device is working properly is
displayed in the dialog box, the driver has been correctly
installed. If any error message is displayed, remove SIIG
CN2487 UDMA133 IDE Controller
and restart your system.
Windows 98/98SE Driver Installation
For New Windows 98/98 SE Systems
1. Follow Microsoft procedures to install Windows accordingly.
2. Once Windows has been installed, double click My
Computer/Control Panel/System , then click Device Manager.
3. Double click Other Devices then PCI SCSI Bus Controller.
4. Click Driver tab, then Update Driver.
5. Insert the Driver diskette and click Next.
6. Select Search for a better driver than the one .... and click
Next .
7. Check Specify a location, uncheck the other boxes, type in
A:\Win9x and click Next. Click Next, Next, then Finish.
8. Remove the Driver diskette and click Yes to restart Windows
to complete driver installation.
For Existing Windows 98/98 SE Systems
1. Boot up Windows.
2. At the Add New Hardware Wizard, click Next.
3. Select Search for the best driver for your device option and
then click Next.
4. Insert the Driver diskette, check Specify a location, uncheck
the other boxes, type in A:\Win9x, and click Next.