SRS Labs Projector 8953H - Manual (Page 39)

39
The projector connected to an access point by the wireless LAN
3.4 Passcode connection (continued)
3. Using the Live Mode
SSID *2: wireless (example)
Encryption: WEP64bit (example)
Encryption key *3: ********** (example)
Subnet mask *4: 255.255.255.128
(example)
1) Enter the following information that is set in
the projector. *1
*1 To find the network setting on the projector, refer to the NOTE. (40)
*2 If you don’t use the factory default SSID, you need to set your SSID by either
entering manually or selecting from the list of detected SSID.
*3 If you use an encryption, you need to set it. Contact the network administrator
to find the encryption key that is set in the projector.
The encryption key is always shown as “**********”.
*4 If you use Subnet mask except Class A/B/C, please set it.
2) Click [Connect].
3) The wireless connection will be established.
Proceed to the item 3.6 Confirm the connection to your destination. (50)