Module state transitions, Figure 10: module state transition diagram, Figure – Siemens TC65 User Manual
Page 23: 2 module state transitions
TC65 JAVA User's Guide
Strictly confidential / Released
s
TC65 JAVA User's Guide_V05
Page 23 of 90
26.09.2005
4.4.2
Module State Transitions
State 1: Default, no Java
appl. running
State 6: Java active,
using SPI
switch on
State 3: no Java appl.
running, using SPI
no Java autostart
Java autostart
start java: at^sjra
destroy java application
destroy
Java application
close I2C
close SPI
open SPI
start java:
at^sjra
open I2C
start java: at^sjra
State 4: Default,
Java active
destroy java application
open SPI
close SPI
close I2C
open I2C
State 5: Java active,
using I2C
State 2: no Java appl.
running, using I2C
Figure 10: Module State Transition Diagram
Note: No AT parser is available over serial interface ASC0 or ASC1 while a Java application
is running on the module. System.out is available on ASC1 for debugging while a Java
application is running.