Sunfire CRW-3 - Manual (Page 7)

User's Manual
7
6. End Caps
These decorative end caps can be
painted to match your room decor. A
paint shield (13) is supplied to cover
the drivers during painting.
7. Ribbon Adjustment
This allows you to adjust the level of
the ribbon section relative to the other
drivers. The range of adjustment is
± 3 dB, and the default setting is in the
middle (0 dB). Perform a listening test
and adjust as desired.
8. Woofers
The CRW-3C uses four identical cus-
tom drivers. The CRW-3 uses 3.
9. Clamp Screws
These screws are used to clamp the
loudspeaker in place, once it has been
pressed into the sheetrock opening of
your wall.
10. Lens (CRW-3C only)
The CRW-3C uses an acoustic lens
over the ribbon to optimize the perfor-
mance as a center loudspeaker.
Front Panel Features
11. Grille
The grille is attached to the main body
with magnets. To remove the grille,
gently pry it away from the corners.
1. Cutout Guide
This allows you to easily mark the
required cutout onto your wall.
13. Paint Shield
This covers the drivers and frame when
painting the end caps to match the
walls.
7 6 8 9 10 11
1
13