Schneider Electric 560125D/2 - Manual (Page 15)

Multi Room Audio Amplifier Installation Instructions
15
5 Commissioning and Testing
Follow these guidelines when testing the functionality of the installation.
• Configure the C-Bus wall switches to control the volume, bass/treble and
muting before connecting an audio source. Refer to the wall switch instruction
documents and to C-Bus Toolkit software Help.
• Be sure to power off amplifiers before connecting audio sources or network
cables. Mute the speakers before connecting or disconnecting.
• Use an MP3 player or other equipment as an audio source.
• Do not Megger test the C-Bus network cable.
• Refer to the
C-Bus Multi Room Audio Amplifier User's Guide for use of controls
and C-Bus wall switches. Also refer to the wall switch documents.
• Refer to the
C-Bus Multi Room Audio Amplifiers User's Guide for information
about headphones and hand held remote control use.
6 Troubleshooting
Symptom Possible Explanation
There is no sound after switching
the Amplifier on (sound worked
previously). The volume may have been set to minimum,
or the Amplifier may have been Muted (on a
Desktop Amplifier) before the Amplifier was
switched off.
The default volume, bass or treble
settings have changed (when
switching the Amplifier on). If a power failure occurs when the Amplifier is
on, the volume, bass and treble settings are
saved and become the new defaults.
An Amplifier switches off,
particularly when the volume is
loud. If insufficient current is available for the
Amplifier, it will switch itself off.
This may occur if the Amplifier receives its
power from a Matrix Switcher.
Cannot hear any sound when
using the optical input Some digital audio formats (such as surround
sound) are incompatible with the MRA
system.