Stanton M.207 - Manual (Page 7)

M.207 Description
1. Mic/Aux Input Selector: Selects the Microphone (MIC) or Auxiliary (AUX) input. You would use the AUX input for
connecting a 3rd audio source, like a CD Player, sampler, or another mixer (session input).
2. Mic/Aux gain (gAIN): Adjusts the volume of the MIC or AUX input.
3. Mic/Aux EQ: Adjusts the HI, MID, and LOW frequency levels of the MIC or AUX input.
4. Mic/Aux FX (FX): Sends the signal to the internal FX processor.
Note Considering that Channels 1 (PH1/LN1) & 2 (PH2/LN2) contain the same controls and functionality; we will
only describe them once and duplicate the numbering:
5. Input Selector Switch: Selects the Phono (PH) or Line (LN) input.
6. Channel gain (gAIN): Adjusts the pre-fader volume of the PH or LN input.
7. Channel EQ: Adjusts the HI, MID, and LOW frequency levels of the PH or LN input.
8. Pan: Controls the Left/Right positioning of the signal within the stereo image.
9. Channel FX (FX): Sends the signal to the internal FX processor.
10. Channel Fader: Controls the output level of the selected input (PH or LN).
11. Level Meter: Displays the pre-channel fader (10) volume.
12. Crossfader: Controls the audio signal that is sent to the outputs. When the Crossfader is set to 1 (hard left), only
channel 1 (PH1/LN1) will be sent to the outputs and when is set to 2 (hard right), only channel 2 (PH2/LN2) will be
sent to the outputs. So if the Crossfader is centered, both channels will be sent to the outputs so you are able to
fade (mix) or cut (scratch) between channels 1 & 2 signals.
13. Frequency FX (LOW, MID, HI): The LOW, MID, and HI buttons can be used to route each particular frequency bands
to the FX processor, or as effects themselves.
14. Automatic and Manual Filter effect (A.FILTER/M.FILTER): If this button is pressed and released, the AUTO FILTER
effect is enabled. When the button is held, it will switch between the MANUAL, HI-PASS, and LOW-PASS filter’s
modes. Release the button when the desired filter is selected.
15. Phaser/Flanger effect (PHASER/FLANgE): If this button is pressed and released, the PHASER effect is engaged.
If this button is pressed and held, then the FLANGER effect is engaged.
16. Echo/Strobe effect (ECHO/STROBE): If this button is pressed and released, the ECHO effect is engaged. If the
ECHO/STROBE button is pressed and held, then the STROBE effect is engaged.
17. Pan/Transform effect (PAN/TRANS): If this button is pressed and released, the PAN effect is engaged. If this button
is pressed and held, then the TRANSFORM effect is engaged.
18. Key effect (KEY): Changes the key of the song without affecting its tempo.
19. Sampler (SAMPLER): Pressing this button will engage the FX sampler mode.
20. Manual Mode (MANUAL): In any of the Auto Filter effects (like PHASER or AUTO FILTER), pressing the MANUAL
button will allow you to manually control the sweep of that effect by using the FXGlide™ touch slider. Pressing
MANUAL again will return the effect to its Auto mode.
4