Sunbeam SR8200 - Manual (Page 7)

5
5.Press and hold the steam release button to
iron with steam. To dry iron, do not press
the steam release button. Both the steam
ready indicator and the boiler thermostat
light will cycle on and off during ironing as
the ironing system maintains the selected
steam pressure and temperature level.
Note: To prevent water dripping from the
soleplate, only use the steam function on
higher temperature settings (
•• and above).
6. Once you have finished ironing, switch the
iron and boiler off by pressing the on/off
button. Switch the power off at the power
outlet and remove the plug. Wait for the
iron to cool completely before storing. Do
NOT empty the boiler.
Filling the boiler when hot
When pressing the steam release button fails to
emit steam and the boiler thermostat light stays
illuminated, the boiler has run out of water.
To refill the boiler:
1.Press the on/off button to switch the
appliance off.
2.Turn the power off and remove the plug
from the power outlet.
3.Wait a few minutes for the boiler to cool,
then loosen the cap slowly to release any
remaining steam in the boiler.
4.Unscrew and remove the cap completely.
5.Wait a few minutes before slowly refilling
the boiler using the funnel provided.
Caution: Use extreme caution when filling
the boiler, as adding cold water into the
hot boiler will immediately produce steam
which can scald skin.
6.Replace the boiler cap and tighten.
7.Follow steps 1 to 4 on page 4 to
recommence ironing.
Storage
If you do not intend to use your professional
ironing system for several weeks, wait until
the appliance has cooled completely, then
unscrew the boiler cap and empty the
remaining water from the boiler before
storing.
Using your professional ironing system continued