Sennheiser 504302 - Manual (Page 10)

9
Overview of the LEDs
Overview of the LEDs
Base station
* during charging, each segment gets brighter in 5 steps
Headset
¿
»
´
³
LED of the PC button ³ Meaning
lights up PC mode
flashes Incoming PC call
LED of the PHONE button » Meaning
lights up Phone mode
flashes Incoming telephone call
LINK LED ¿ Meaning
lights up blue Active link to the headset
lights up red No link to the headset
flashes red Headset is muted
is off Standby mode
Base station is switched off
(not powered)
´
CHARGE STATUS LED
´
LED segment* Battery charge Required charging time
1 0-25% approx. 10 min
2 25-50% approx. 10 min
3 50-75% approx. 20 min
4 75-100% approx. 20 min
When the LED segment 1 flashes in rapid succession, the battery is
almost flat. You have to recharge the battery within the next few
minutes (see also page 22).
3
HEADSET LED ቤ Meaning
lights up blue
(when placed into base station)
Charging mode
flashes blue slowly Active link to base station
flashes red Rechargeable battery is almost flat
if off Standby mode
Headset is switched off
flashes blue/red Setting mode/GAP pairing mode
Pairing of an additional headset to the
base station
total:
approx.
60 min