Sennheiser 504302 - Manual (Page 32)

31
Using the headset system
Pairing is not successful If pairing is not successful within 60 seconds, the DW Office headset
switches to standby mode.
̈
For information on how to pair the headset to the non-DW Office base
station, refer to the instruction manual of the base station.
Charging an additional headset
If you wish to charge an additional headset (headset b ) in the base station
while you are using your headset (headset a ):
̈
Make sure that a wireless link is established between headset a and
base station (the LINK LED
¿
on the base station lights up blue).
̈
Place headset b into the base station.
Headset a can continue to connect to and disconnect from the base
station and its use is not restricted while headset b is being charged.
If you leave the DECT range
If you leave the DECT range during a call, the audio quality deteriorates.
When the link breaks down completely, you hear a descending sequence
of beeps in the headset and the LINK LED
¿
on the base station lights up
red.
To resume the call:
̈
Re-enter the DECT range of the headset system within 60 seconds.
As soon as the headset re-establishes the wireless link to the base
station, you hear a ring tone in the headset.
̈
Press the LINK button ብ on the headset to resume the call.
If a handset lifter/electronic hook switch is used or if your soft-
phone supports call control, the call will automatically be ended
60 seconds after leaving the DECT range.