Sub-Zero UC15IO - Manual (Page 13)

Ice Machine Installation 13
subzero.com/specs
Panel Installation
Exercise caution when drilling holes for mounting
hardware. This is especially critical with inset panels.
If the reveal on the hinge side of the door panel is less
than 1 / 4 ", and the panel has a square corner, severe
finger pinching or damage to the unit may occur.
Installation
INSTALL KICKPLATE
Once the ice machine is in position, install the kickplate
using the screws provided. The kickplate must be
removed for servicing. The floor cannot interfere with
removal. Do not cover the vents of the kickplate to allow
proper airflow. The door panel may hang in front of the
vents, but a decorative kickplate must not cover the vents.
If you choose, the kickplate may be painted another color.
Follow these steps: Rough up the surface to be painted
with fine grit sandpaper. Wipe with alcohol to ensure that
the surface is clean and dry. Use an appliance or industrial
grade, oil base, high gloss enamel paint. SIDE PANEL INSTALLATION
With the ice machine, you must securely fasten side
panels to adjacent cabinets and floor. Brackets and
screws are provided for mounting the unit to adjoining
cabinets and side panels.
Side panels should be fastened to the floor and walls
using L-shaped brackets (not included). To help move the
unit into place, rout out an area in the floor so the bracket
will sit flush with the floor.