Sanyo AVL-279 - Manual (Page 45)

Changing Volume Lock
The remote comes preset to allow independent volume control of each selected
device (Global Volume Unlock). However, you may change the Volume Lock setting
to Global Volume Lock so that one device's volume will control volume in all other
modes. After that, you can perform Individual Volume Unlock on a selected device to
set its volume control for independent operation or Global Volume Unlock to remove
all volume locking.
Locking Volume Control to One Mode (Global Volume Lock)
1. Press and hold SET until the red LED blinks twice; then release.
2. Enter 9-9-3 and then press the mode key for the device you want to control volume
(for example, TV). The LED blinks twice. Now when you press VOL+, VOL-, or
Mute, the selected device (for example, TV) will control the volume regardless of
the current mode.
Unlocking All Volume Control (Restoring Global Unlock)
1. Press and hold SET until the red LED blinks twice; then release.
2. Enter 9-9-3 and then press VOL+. The LED blinks four times.
Volume is now independently controlled for all programmed devices.
Unlocking a Single Device's Volume Control
1. Press a device key (TV, VCR/DVD, CBL/ SAT, or AUX).
2. Press and hold SET until the red LED blinks twice; then release.
3. Enter 9-9-3 and then press VOL-. The LED blinks four times.
Volume is now independently controlled for the selected devices.
Troubleshooting
Programming your Remote Control
Problem Solution
LED does not blink when you
press a key. Replace new batteries.
LED blinks when you press a
key, but device does not
respond. Make sure the remote is aimed at your device and is
not more than 15 feet away.
An entry error has occurred (for example, wrong key).
Try entry sequence again.
Remote does not control devices
or commands are not working
properly. Try all listed codes for the device. Make sure the
device operates with an infrared remote control.
CH+, CH-, and LAST do not work
for your RCA TV. Due to RCA design from 1983 to 1987, only the
original remote control will operate these functions.
C h a n n e l s d o n o t c h a n g e
properly. If the original remote control required you to press
Enter to change channels, press Enter on this remote
after entering the channel number.
CARE
=
=
=
=
Keep the remote dry. If it gets wet, wipe it dry immediately.
Use and store the unit only in normal temperature environments.
Handle the remote gently and carefully. Don't drop it.
Wipe the remote with a damp cloth to keep it looking like new.
44
Other Information