SIGMA Category 1 User Manual
Page 16
Teaching New Radio Transmitters to the Security System
IM P O R TANT NOTICE:
When teaching one or more radio transmitters into the security system all previous
radio transmitters will be erased from the security system. You must always teach
ALL the radio transmitters required to operate the security system during the
Teaching New Radio Transmitters to the Security System process.
Note:
When using the keypad, each time a button is pressed the LED on the keypad will
flash once as confirmation. The next button should not be pressed before this
confirmation. However, you only have 10 seconds to enter the next character. If you
do not press the next character within this time period the LED on the keypad will
flash repeatedly, after which you must start the sequence again from the beginning.
W ith the ignition switched off and the security system disarmed, type into the keypad the
following:
Where A A A A represents the 4-digit PIN code and n represents the total number of radio
transmitters to be recognised by the security system (maximum 4). To confirm correct
input of you PIN code the siren will bleep after entering the last digit. The numeric 91 i
s
the access code or command, which tells the alarm unit to accept the new transmitters.
Then immediately give the button on the first radio transmitter a quick press, the siren will
bleep, now give the button on the second radio transmitter a quick press, the siren will
bleep again, continue with third and fourth radio transmitters (if applicable). After pressing
your final radio transmitter wait 10 seconds. Finally test that all your radio transmitters arm
and disarm the security system.
Example
So for example if the PIN code is 1234 and you wish to programme in 2 radio
transmitters you would type in:
Then press the remote keys at the appropriate time.
Example only
A
A
A
A
9
1
n
#
Q
Q
Q
Q
1
2
3
4
9
1
2
#
Q
Q
Q
Q
Your PIN code (the alarm will bleep)
Notifies the alarm that you want to programme the radio transmitters
Is the number of radio transmitters that you want to programme in
Confirms you want to program radio transmitters and will be followed by a bleep
14
X i. Universal Opins.qxd 24/09/2004 11:44 Page 16