Sharp XG-NV7XU - Manual (Page 18)

E-17
Operation
Basic Operations
4
3
3 Rotate the focus ring until the image on the screen
becomes clear.
4 Rotate the zoom ring. The image can be adjusted
to the desired size within the zoom range.
6
7
8
5
5 Press INPUT to select the desired input mode.
Press INPUT again to change the mode.
EXAMPLE
INPUT 1 Mode
INPUT 2 Mode
VIDEO Mode
f
f
• When no signal is being received, “NO SIGNAL” will be
displayed. When a signal that the projector is not preset
to receive is being received, “NOT REG.” will be displayed.
6 Press VOLUME ؀/؁ to adjust the volume.
7 Press MUTE to temporarily turn off the sound.
Press MUTE again to turn the sound back on.
8 Press POWER OFF.
Press POWER OFF again while the message is
displayed.
5
6
7
8
• If you accidentally pressed POWER OFF and do not want
to turn off the power, wait until the power off screen
disappears.
• When POWER OFF is pressed twice, the POWER indicator
will light up red and the cooling fan will run for about 90
seconds. The projector will then enter standby mode.
• Wait until the cooling fan stops before disconnecting the
power cord.
• The power can be turned on again by pressing POWER
ON. When the power is turned on, the POWER indicator
and the LAMP REPLACEMENT indicator light green.