Sony HD100 - Manual (Page 10)

10
Connecting Your Digital Monitor
Connect your TV to the Digital Satellite Receiver as shown below.
VIDEO
IN
VGA
L(MONO)
R
S VIDEO
IN
-AUDIO-
Y
P B
P R
VHF/UHF IN
VHF(SAT)/UHF
OUT VGA OUT
ACCESS CARD
TEL LINE AC IN~
®
UL LI ST ED 9C 06
V ID E O /A UDIO PR O D U C T
CAUTION
VIDEO
Y
P B
P R
1 2 3
(MONO)
L
R
S VIDEO
AUDIO
AUDIO/VIDEO OUT
RF
REMOTE
SATELLITE IN
VHF/UHF IN (DTV)
VCR
CONTROL
LOW SPEED
DATA
DIGITAL
AUDIO
OUT
(OPTICAL)
IN
Y
P B
P R
Connect the
AUDIO/VIDEO1 or
AUDIO/VIDEO2 jacks
Connect the AUDIO/
VIDEO OUT jacks on your
Digital Satellite Receiver to
the A/V input jacks on
your Digital TV using the
supplied A/V cable. (Be
sure to match the colors on
the jacks with the colored
plugs on the A/V cable.)
If your Digital TV has only
one audio input, connect it
to the L(MONO) jack on the
receiver.
If your Digital TV has a
VGA input jack
Connect the VGA OUT jack to
the VGA input jack on your
TV using VGA cable (not
supplied).
A/V Cable
VIDEO
(yellow)
OR
S-Video
S-Video
Cable
TV
VGA
Cable
1a
1b
2b
If your Digital TV has an
S-Video input jack
Use the S-Video cable
instead of the yellow video
connection.
If your Digital TV has
Y/P
B /P R input jacks
Connect the Y/P B /P R OUT
jacks to the Y/P B /P R input
jacks on your TV using the
supplied Y/P
B /P R cable.
2a
2a 1a 2b 1b
z Tip
Use both the VIDEO 1 or VIDEO 2
OUT jacks and the VIDEO 3 or VGA
OUT jacks to connect your Digital
Satellite Receiver to your digital
monitor. The VIDEO 3 or VGA OUT
jacks will send the best quality
signal to your digital monitor. The
VIDEO 1 or VIDEO 2 OUT jacks will
give you the option to view or
record programs with high
definition copyright restrictions.
Y/P B /P R
Cable
Digital Satellite Receiver
Step 2: Connecting Your Analog TV Set or Digital Monitor
(continued)