Sony RM-VL600 - Manual (Page 19)

19
Continued
When you “teach” signals to
VOL +/– or MUTING
•If you used the Learning
function to program the VOL +/–
or MUTING buttons to send any
signal to components other than
the TV or AMP, that signal will
be transmitted only by pressing
VOL +/– or MUTING when you
select that component.
•If you used the Learning
function to program the VOL +/–
or MUTING buttons to send any
signal to the TV or AMP, that
signal will be transmitted only
after you select TV or AMP.
When you select other
components, the “learned”
signal will be transmitted.
To “teach” the signals for an
air-conditioner
See “Notes on programming the
signals for an air-conditioner” on
page 24.
For accurate Learning
• Do not move the remote units
during the Learning procedure.
• Be sure to keep holding down
the “learning” button until your
Commander reacts as described.
• Use fresh batteries in both
remote units.
• Avoid Learning in places subject
to direct sunlight or a strong
fluorescent light. (Noise may
interfere during the Learning
procedure.)
• The remote control detector area
may differ depending on each
remote unit. If Learning does not
work, try changing the positions
of the two remote control units.
• When you teach signals of an
interactive signal exchange
system remote control unit
(supplied with some of Sony’s
amplifiers) to the Commander,
the response signal of the main
unit may interfere with the
learning of the Commander. In
such a case, move to a place
where the signals will not reach
the main unit (e.g. other rooms,
etc.).
IMPORTANT
Be sure to place the
Commander out of the reach of
small children or pets, and lock
the controls using the Hold
function (page 34).
Components such as air
conditioners, heaters, electric
appliances, and electric
shutters or curtains receiving
an infrared signal can be
dangerous if misused.