SOYO SY-6IZM/3 - Manual (Page 11)

SY-6IZM/3 Quick Start Guide
11
Hardware Installation
Note on Over-clocking Capability
The 6IZM/3 Motherboard provides over-clocking capability. Due to the over-clocking setting
your system may fail to boot up or hang during run time. If this occurs, please perform the
following steps to recover your system from the abnormal situation:
1. Turn off system power (If you use a ATX power supply, sometimes you have to press
the power button for more then 4 seconds to shut down the system)
2. Set the JP3 to pin 2-3 short if you use a FSB 66MHz CPU
3. Press and hold down the <Insert> key while turning on the system power. Keep
holding down the <Insert> key until you see the message of the CPU type and
frequency (133MHz or 200MHz) appear on screen
4. Press the <Del> key during the system diagnostic checks to enter the Award BIOS
Setup program
5. From the BIOS main menu, select [SOYO COMBO] and move the cursor to the [CPU
Frequency] field to set the proper working frequency
6. Select [Save & Exit SETUP] and press <Enter> to save the configuration to the
CMOS memory, and continue the boot sequence
Note: SOYO does not guarantee system stability if the user over clocks the system.
Any malfunctions due to over-clocking are not covered by the warranty.