SOYO SY-6IZM/3 - Manual (Page 6)

SY-6IZM/3 Quick Start Guide
6
Hardware Installation
Install the Motherboard
Follow the steps below in order to perform the installation of your new SY-6IZM/3 Motherboard.
Step 1.
Install the CPU
Mark your CPU Frequency: Record the working frequency of your CPU
that should be clearly marked on the CPU cover.
FSB 66MHz
266MHz (66 x 4.0) 333MHz (66 x 5.0) 400MHz (66 x 6.0)
300MHz (66 x 4.5) 366MHz (66 x 5.5) 433MHz (66 x 6.5)
FSB 100MHz
350MHz (100 x 3. 5) 450MHz (100 x 4.5) 550MHz (100 x 5.5)
400MHz (100 x 4.0) 500MHz (100 x 5.0) 600MHz (100 x 6.0)
CPU Mount Procedure: To mount the processor that you have purchased
separately, follow these instructions.
Retention Module
Step 1. Open the two sides by folding them up.
Step 2. Push the locks on top of the CPU
inward. Step 3. Insert the CPU into the retention
module. The CPU fits in the CPU slot in
only ONE way, do not try to force it in.
Step 4. After completely inserting the CPU, push the two locks on
top of the CPU outward. Now your CPU is ready for use.
T o remove the CPU, press
the two notches on top of
the CPU inward. Now
press the two slides on the
retention module down and
remove the CPU.
Note: Installing a heat sink and cooling fan on top of your CPU is necessary for proper heat dissipation.
Failing to install these items may result in overheating and possible burn-out of your CPU.