Sony MZ-R5ST - Manual (Page 26)

26
Erasing tracks (ERASE)
To erase a track
Make sure of the track you are erasing.
1
Press ERASE/DELETE while playing
the track you want to erase.
“Erase OK? n Push Enter” appears
in the display, and the recorder plays
the selected track repeatedly. To
cancel erasing, press
p.
2
Check the track number in the
display and press TITLE/ENTER.
The track is erased from the MD and
the remaining tracks are renumbered.
The recorder will start to play the
next track.
To erase a part of a track
Add track marks (page 27) at the
beginning and the end of the part you
want to erase, then erase the part.
z Editing recorded tracks
You can edit your recordings by adding/
erasing track marks or labeling tracks and
MDs. Premastered MDs cannot be edited.
Notes on editing
•Do not move or jog the recorder while “Toc
Edit”* is flashing in the display.
•You cannot edit tracks on an MD that is
record-protected. Before editing tracks,
close the tab on the side of the MD.
*TOC = Table of Contents
To erase the whole disc
You can erase all the tracks and data of
the MD at the same time.
Be sure to check the contents of the disc
you want to erase.
1
In stop mode, keep pressing ERASE/
DELETE and press and slide REC to
the right.
“All Erase OK ? n Push Enter”
appears in the display. To cancel
erasing, press
p.
2
Press TITLE/ENTER.
”Toc Edit” flashes in the display.
When the MD is erased, “BLANK
DISC” appears.
p
p REC
ERASE/
DELETE
ERASE/
DELETE
TITLE/
ENTER
TITLE/
ENTER