Sony MZ-R5ST - Manual (Page 9)

9
Record an MD.
4
1 Press and slide REC to the right .
“REC” lights up in the display and
recording starts.
2 Play the CD or tape you want to
record.
To stop recording, press p.
Note
”Toc Edit” flashes while data of the
recording (the track’s start and end points,
etc.) is being recorded. Do not move or jog
the recorder or disconnect the power source
while the indication is flashing in the
display.
To
Pause
Record part way through the
previous recording
2)
Remove the MD
Turn power off
Press
P 1)
Press P again to resume recording.
(, + or = to find the start point
of recording and press
p to stop. Then
slide REC.
p and open the lid. 3)
Press POWER
REC
CD player, etc.
(source)
1) A track mark is added at the point where you press P; thus the remainder of the track will be
counted as a new track.
2) If you start a new recording partway from a previous recording, the previous recording will be
overwritten (erased) by the new one.
3) Once you open the lid, the point to start recording will change to the beginning of the first track.
Check the point to start recording on the display.
If the recording does not start
•Make sure the MD is not record-protected
(page 40).
•If "SCMS NO COPY" is displayed, you
cannot record digitally (page 40).
•Premastered MDs cannot be recorded over.
For models supplied with the AC plug
adaptor
If the AC power adaptor does not fit the wall
outlet, use the AC plug adaptor.
z
•You can monitor the sound during
recording. Plug in the headphones to the
2HEADPHONES jack on the station, or to
2/REMOTE jack on the recorder. Note that
the quality of sound through the
headphones connected to the recorder is
inferior to that connected to the station. Use
it to confirm recording.
•The power turns off automatically if you
leave the station unoperated for 5 minutes
during stop. Press
( to turn the power on
again.