Sony CD145 - Manual (Page 33)

Answering machine 31
6.11 How to remotely
access your
answering machine
This feature lets you check
your messages, or otherwise
operate your answering
machine by calling the
answering machine and
entering a remote access code
on a tone dialling phone.
You can activate the remote
access control feature by:
Place a call from an external
phone to your CD145
When the answering
machine answers the call
and starts playing the
outgoing message, press #
Enter the 4-digit remote
access PIN (default remote
access PIN is 0000)
Note
If the PIN is correct, recorded
messages would be playback
automatically.
However, if the PIN is incorrect,
an error tone would be heard,
you can retry to enter the
remote access PIN again.
If there are new messages, all
the new messages will be
played immediately and then
3
2
1
6.9 How to delete all
incoming messages
In idle mode:
Press and hold for two
seconds to delete all old
messages.
Note
New messages that have not
been heard cannot be deleted.
6.10 How to screen an
incoming call
You can listen through the
speaker while your answering
machine takes a call.This lets
you identify the caller and
decide whether to take the call
or not. Once you press
to
pick up the call, the recording
will stop automatically.
Five speaker volume levels are
available. In idle mode, press
repeatedly to adjust the
speaker volume to the lowest
level to turn off the call
screening.You can press
to
increase the speaker volume to
turn on the call screening.
1