Sun Microsystems Sun Fire V40z User Manual
Page 38
32
Sun Fire V20z and Stinger4 Servers Linux Operating System Installation Guide • May, 2004
10. For CD Installation Only: Insert the requested CD at the appropriate time.
All of the CDs may not be required, depending upon the software selected at the
beginning of the installation process.
After the installer has finished with the needed media, the installer will prompt you
to enter the root password.
11. Enter a root password of your choosing.
Note –
be suer to note the password in a safe place. If you forget it, you may have
to reinstall the operating system.
The Network Configuration screen displays with network interfaces detected by the
installer.
12. Select Accept to accept the network configuration, or change the settings as
necessary.
13. When prompted to test the Internet connection, select Yes or No.
It is recommended that you skip this test.
14. At the User Authentication Method screen, select the appropriate authentication
method for your environment.
■
If you choose Stand-Alone, the installer prompts you to add a new user. You can
add additional users, or select Next.
■
If you chose for the server to become a network client, you are prompted for the
appropriate configuration parameters.
15. Read the displayed Release Notes and select Next.
16. Verify the settings in the Hardware Configuration screen and select Next.
The system saves the configuration settings, and the Installation Completed screen is
displayed.
17. Select Finish to complete the installation.
18. Proceed to “Updating the Operating System and Drivers” on page 38.