Sennheiser SKM 5200 - Manual (Page 26)

28
If problems occur ...
Error checklist
If problems occur that are not listed in the above table or if the
problems cannot be solved with the proposed solutions, please
contact your local Sennheiser agent for assistance.
Problem Possible cause Possible solution
No operation
indication Batteries are flat or
inserted incorrectly,
battery pack is flat Replace the batteries or
check if they are
inserted correctly or
recharge the battery
pack
Transmitter
cannot be
switched off/
Settings cannot
be changed Lock mode is activated Deactivate the lock
mode (see
“Deactivating the
autolock function
temporarily” on page
16)
Receiver:
No RF signal Transmitter and
receiver are not on the
same channel Set transmitter and
receiver to the same
channel
Transmitter is out of
range Check the squelch
threshold setting
or reduce the distance
between receiving
antenna and
transmitter
Weak signal Antenna signal is
attenuated Do not clasp the
antenna section
Audio signal
has a high level
of background
noise Transmitter’s input
attenuation is adjusted
too high See “Adjusting the
microphone sensitivity
– ATTEN” on page 25
Receiver’s output level
is adjusted too low Increase the line output
level
Audio signal is
distorted Transmitter’s input
attenuation is adjusted
too low See “Adjusting the
microphone sensitivity
– ATTEN” on page 25
Receiver’s output level
is adjusted too high Reduce the line output
level
SKM 5200_512717_0506_Sp6.book Seite 28 Donnerstag, 7. Dezember 2006 3:28 15