Samsung ML-1200 - Manual (Page 12)

S ETTING U P Y OUR P RINTER 2.7 S ETTING U P Y OUR P RINTER 2.6
Connect to the Computer with a
Parallel Cable
(ML-1210 Only)
1
Plug the power cord into the power
receptacle on the back of the printer.
2
Plug the other end into a properly
grounded AC outlet.
3
Turn on the power.
Turn on the Printer
To AC outlet
As the printer powers up, all the printer
control panel lights turn on briefly. When
only the Data light remains on, press and
hold the Demo button.
Hold down the button for about 2 seconds
until all lights blink slowly, then release,
the demo page will print.
ML-1210 / ML-1220M / ML-210
Excellent Performance
Saving & Convenience
Compatibility
Laser Beam Printer
The demo page provides a sample of the
print quality and helps you verify the
printer is printing correctly.
Print a Demo Page!
➜
1
Make sure both the printer and the computer are turned off.
2 Plug the parallel printer cable into the
connector on the back of the printer.
Push the metal clips down to fit inside
the notches on the cable plug.
3
Connect the other end of the cable to
the parallel interface port on your
computer, and tighten the screws.
See your computer documentation if
you need help.
To the parallel
port on PC
➜
If you are using a USB interface
Go to “Using Your Printer with a USB Cable” on
page
A.10 .
Note: To connect the printer to the parallel port of the computer
requires a certified parallel cable.
You will need to buy the IEEE1284 compliant cable.