Siemens C2 - Manual (Page 7)

7
Preparing to use your phone
Gigaset C2 / englisch / A31008-C002-B001-2-QD19 / start_guide_time.fm / 28.03.2003
Placing the handset into the base (registering) and charging the batteries
When you place the C 2 handset into the C 200/C 250, C 100/C 150 or S 100/S 150 base,
it will register to the base automatically. Proceed step by step as follows:
1. Place the handset in the base with the display up.
2. Wait till the handset has registered automatically to the base: This operation takes
around one minute. While registration is in progress the screen displays
Registering
and Base 1 flashes. The allocated internal number appears in the top
left of the display after registration.
3. Now leave the handset in the charging shell for the batteries to charge - the batteries
are supplied uncharged. Battery charging is indicated in the top right of the display
by the flashing battery icon = .
The battery charging status is correctly displayed only after uninterrupted charging/
discharging. You should therefore avoid removing the batteries unnecessarily and
ending the charging process prematurely.
Manual registration
If automatic registration is interrupted or if you wish to use your C 2 handset at a
different Gigaset base (1000, 2000, 3000 or 4000 family), then you must register it
manually. You must initiate handset registration on the handset and on the base.
W
For the initial charge we recommend a continuous, uninterrupted
charging period of five hours, whatever charge status is indicated. After
a while the charge capacity of the batteries will decrease for technical
reasons.
i
◆ Once initial charging is complete, you can replace your handset in the
charging shell after each call. Charging is controlled electronically.
This ensures that the batteries are charged in a way that maximises
their life.
◆ The batteries heat up during charging. This is normal and not
dangerous.