Sharp UX-340L - Manual (Page 49)

Setting Up and Using OpenLCR
47
2. S
e
tting Up
O
penLCR
Selecting a long or short call
Before you make a long distance or international phone/fax call, select
whether the call will be a long call or a short call.
Your fax needs to know
whether the call will be
long or short to route it
for the best rate.
1
Press these keys:
The display will show:
LCR TABLE SELECT
1=02MIN, 2=04MIN
FUNCTION
2
Press 1 to select the SHORT TIME
setting, or 2 to select the LONG
TIME setting.
•
The initial SHORT TIME setting is 2
minutes, and the initial LONG TIME
setting is 4 minutes. If desired, you
can change these settings as explained
on the following page.
•
The short/long time selection will
remain in effect for all calls until you
change it.
1 2 or
SHORT LONG
Note: If the display shows
TABLE NOT EXIST, you must
first download the rate data.
Note: The following settings are not required as of the printing
of this manual. OpenLCR will inform you through its Web site
(www.OpenLCR.com) if the settings become necessary in the future.
OpenLCR
all-ux340L.book Page 47 Thursday, December 23, 1999 5:37 PM