Schumacher PID-750 - Manual (Page 4)

3
• Only connect the Power Inverter to a 12-Volt battery. Make
sure the AC plug connection is tight.
• Do not modify the AC receptacle in any way.
• Use only 45-amp fuses.
• This device does not include an internal Ground Fault
Circuit Interrupter (GFCI). For GFCI protection, use a
Coleman Cable 02822 GFCI outlet.
WARNING: Handling the cord on this product or cords as-
sociated with accessories sold with this product, may expose
you to lead, a chemical known to the State of California to
cause cancer and birth defects or other reproductive harm.
Wash hands after handling.
BEFORE USING PID-750 POWER INvERTER
It is important to know the continuous wattage of the
device you plan to use with the inverter. The PID-750 must
be used with devices drawing 750 watts or less. If the
wattage is not marked on the device, an estimate can be
made by multiplying the AC input current (Amps) by the AC
voltage (110V).
Devices like TVs, fans or electric motors require additional
power to start (commonly known as the “starting or peak
power”). The PID-750 can supply a momentary surge
in wattage; however even devices rated less than the
maximum 750 watts can exceed the inverters surge capa-
bility and cause an automatic overload shutdown.